The installation steps of the linear guide are: before installing the linear guide, the burrs, dirt and surface scars on the mechanical installation surface must be removed.
Gently place the main rail on the bed, and use lateral fixing screws or other fixing fixtures to lightly fit the linear rail and the lateral installation surface. Note: Before installation and use, make sure that the screw holes are consistent. If the machined holes of the base do not match and forcibly tighten the bolts, it will greatly affect the combination accuracy and quality of use.
Tighten the set screws of the slide rail slightly from the center to both sides in order to make the rail slightly fit the vertical installation surface. The sequence is to start from the central position and tighten to both ends to get a more stable accuracy. After the vertical reference surface is slightly tightened, the locking force of the lateral reference surface is strengthened, so that the main rail can surely fit the lateral reference surface.
Use a torque wrench to slowly tighten the set screws of the slide rail according to the tightening torque of various materials.
Use the same installation method to install the secondary rails, and install the sliding seat to the main rail and the secondary rail individually. Note that after the slide is installed on the linear slide, many subsequent accessories cannot be installed due to the limited installation space. All the required accessories must be installed at this stage. (Accessories may be oil nipple, oil pipe joint, or dustproof system, etc.)
Gently place the moving platform (table) on the sliding seats of the main rail and the secondary rail.
Tighten the lateral tightening screws on the mobile platform first. After installation and positioning, it will be carried out in the following order
GY offers a complete range of rails and nuts. Why not set us the linear challenge?